| pgpool-II 4.2.3 Documentation | |||
|---|---|---|---|
| Prev | Up | Chapter 5. Server Configuration | Next |
Pgpool-II can work with PostgreSQL native Streaming Replication, that is available since PostgreSQL 9.0. To configure Pgpool-II with streaming replication, set backend_clustering_mode to 'streaming-replication'.
Pgpool-II assumes that Streaming Replication is configured with Hot Standby on PostgreSQL, which means that the standby database can handle read-only queries.
Specifies the time interval in seconds to check the streaming replication delay. Default is 0, which means the check is disabled.
This parameter can be changed by reloading the Pgpool-II configurations.
Specifies the PostgreSQL user name to perform streaming replication check. The user must have LOGIN privilege and exist on all the PostgreSQL backends.
Note: sr_check_user and sr_check_password are used even when sr_check_period is set to 0 (disabled) for the identification of the primary server.
This parameter can be changed by reloading the Pgpool-II configurations.
Specifies the password of the sr_check_user PostgreSQL user to perform the streaming replication checks. Use '' (empty string) if the user does not requires a password.
If sr_check_password is left blank Pgpool-II will first try to get the password for sr_check_user from pool_passwd file before using the empty password.
Pgpool-II accepts following forms of password in either sr_check_password or pool_passwd file:
Most secure and recommended way to store password. The password string must be prefixed with AES. You can use pg_enc utility to create the correctly formatted AES encrypted password strings. Pgpool-II will require a valid decryption key at the startup to use the encrypted passwords. see Section 6.4.2 for more details on providing the decryption key to Pgpool-II
Not so secure as AES256, but still better than clear text password. The password string must be prefixed with MD5. Note that the backend must set up MD5 authentication as well. You can use pg_md5 utility to create the correctly formatted MD5 hashed password strings.
Not encrypted, clear text password. You should avoid to use this if possible. The password string must be prefixed with TEXT. For example if you want to set mypass as a password, you should specify TEXTmypass in the password field. In the absence of a valid prefix, Pgpool-II will considered the string as a plain text password.
This parameter can be changed by reloading the Pgpool-II configurations.
Specifies the database to perform streaming replication delay checks. The default is "postgres".
This parameter can be changed by reloading the Pgpool-II configurations.
Specifies the maximum tolerance level of replication delay in WAL bytes on the standby server against the primary server. If the delay exceeds this configured level, Pgpool-II stops sending the SELECT queries to the standby server and starts routing everything to the primary server even if load_balance_mode is enabled, until the standby catches-up with the primary. Setting this parameter to 0 disables the delay checking. This delay threshold check is performed every sr_check_period. Default is 0.
This parameter can be changed by reloading the Pgpool-IIconfigurations.
Specifies when to log the replication delay. Below table contains the list of all valid values for the parameter.
Table 5-9. Log standby delay options
| Value | Description |
|---|---|
| 'none' | Never log the standby delay (the default) |
| 'always' | Log the standby delay if it's greater than 0, every time the replication delay is checked |
| 'if_over_threshold' | Only log the standby delay, when it exceeds delay_threshold value |
This parameter can be changed by reloading the Pgpool-II configurations.