[pgpool-general: 8248] Re: load_balance_mode is off by default but balancing works?
Nikolay Mastilo (HM)
nikm71 at hotmail.com
Sat Jun 25 04:25:27 JST 2022
Hello,
We run docker image pgpool/pgpool:4.2.2 in Kubernetes.
I found that
- if I set load_balance_mode off, load balancing doesn't work
- if I remove load_balance_mode parameter from environment variables
list, assuming the default value of load_balance_mode, load balancing
works! And 'pgpool SHOW load_balance_mode' command returns 'on'.
Regards,
Nikola
22.06.2022 12:17, Bo Peng пишет:
> Hello,
>
>> For our Pgpool, we did not set the parameter load_balance_mode. Its
>> default is off. When we noticed this, we checked it by command "pgpool
>> show load_balance_mode". Check returned 0. This means balancing was
>> disabled. Correctly?
>>
>> However, the load balancing worked, according to various checks (for
>> example, "show pool_nodes" command), read requests were routed to
>> read-only replicas.
>>
>> Could you comment on this behavior of Pgpool?
> If you are using Pgpool-II 4.3, the default value of
> load_balance_mode is "on".
>
> https://www.pgpool.net/docs/latest/en/html/runtime-config-load-balancing.html#GUC-LOAD-BALANCE-MODE
>
>> Thanks in advance.
>>
>> --
>> Regards,
>> Nikola
>>
>> _______________________________________________
>> pgpool-general mailing list
>> pgpool-general at pgpool.net
>> http://www.pgpool.net/mailman/listinfo/pgpool-general
>
More information about the pgpool-general
mailing list