[pgpool-general: 8228] load_balance_mode is off by default but balancing works?
Nikola(HM)
nikm71 at hotmail.com
Mon Jun 20 23:46:31 JST 2022
Hello,
For our Pgpool, we did not set the parameter load_balance_mode. Its
default is off. When we noticed this, we checked it by command "pgpool
show load_balance_mode". Check returned 0. This means balancing was
disabled. Correctly?
However, the load balancing worked, according to various checks (for
example, "show pool_nodes" command), read requests were routed to
read-only replicas.
Could you comment on this behavior of Pgpool?
Thanks in advance.
--
Regards,
Nikola
More information about the pgpool-general
mailing list