pgpool-II 4.2.7 Documentation
PrevUpChapter 2. Installation of Pgpool-IINext

2.5. Installing Pgpool-II

After extracting the source tarball, execute the configure script. 

    ./configure

You can customize the build and installation process by supplying one or more of the following command line options to configure:

--prefix=path

Specifies the top directory where Pgpool-II binaries and related files like docs will be installed in. Default value is /usr/local.

--with-pgsql=path

Specifies the top directory where PostgreSQL's client libraries are installed. Default value is the path provided by pg_config command.

--with-openssl

Pgpool-II binaries will be built with OpenSSL support. OpenSSL support is disabled by default.

--enable-sequence-lock

Use insert_lock compatible with Pgpool-II 3.0 series (until 3.0.4). Pgpool-II locks against a row in the sequence table. PostgreSQL 8.2 or later which was released after June 2011 cannot use this lock method.

--enable-table-lock

Use insert_lock compatible with Pgpool-II 2.2 and 2.3 series. Pgpool-II locks against the insert target table. This lock method is deprecated because it causes a lock conflict with VACUUM.

--with-memcached=path

Pgpool-II binaries will use memcached for in memory query cache. You have to install libmemcached.

--with-pam

Pgpool-II binaries will be built with PAM authentication support. PAM authentication support is disabled by default. 

    make
    make install

This will install Pgpool-II. (If you use Solaris or FreeBSD, replace make with gmake)

PrevHomeNext
Getting The SourceUpInstalling pgpool_recovery